Columns

How to Choose a Great MCM Fabricator

Part 3: Systems The basic MCM sheet produced by the MCM manufacturers arrives flat and like a blank canvas for MCM Fabricators. That blank canvas can turn into a marginal covering that lasts for a season or into a masterpiece that lasts for the ages. The attachment systems, and their performance, determine to a large… Continue reading How to Choose a Great MCM Fabricator

Part 3: Systems

The basic MCM sheet produced by the MCM manufacturers arrives flat and like a blank canvas for MCM Fabricators. That blank canvas can turn into a marginal covering that lasts for a season or into a masterpiece that lasts for the ages. The attachment systems, and their performance, determine to a large extent whether the air and water will be kept out of the building. The system’s ability to distribute the applied wind and thermal expansion will determine whether the panels will remain on the building and provide assured performance.

That is why tested systems are an important part of the Premium Certified Fabricator program. In order for a system to qualify for this section, it must be owned by the applicant and meet each requirement listed below.

MCM System Requirement

1. ASTM E 283: Static Air Infiltration-No more than 0.06 CFM per SF at 6.24 loading.

2. ASTM E 330: Structural Design Load-Deflection of framing members shall not exceed L/60 of the clear span or shall anchor deflection exceed 1/16-inch at + or – 30 PSF.

3. ASTM E 331: Static Water Infiltration-No uncontrolled water passing from the panel system onto the substrate at 12.0 PSF Loading.

The test reports for each system should be from a laboratory accredited by the International Accreditation Service Inc. or equivalent accreditation organization.

The MCA Certified Fabricator Requirements:

Number of Systems Certified Points

One 5

Two 8

Three 10

Required documentation: The applicant must provide copies of test reports for each company owned system with corresponding accreditation from the testing laboratory. The test reports must be in the name of the applicant.

Bottom line: A MCA Premium Certified Fabricator has had its systems proven by an accredited independent third party in a laboratory. Use them with confidence.

Ted S. Miller is the CEO of The Miller Clapperton Partnership Inc., Austell, Ga. For more information, visit www.millerclapperton.com.